Power Supply and UEFI
Level 4 · Power and start-up
How a power supply changes wall power into 12, 5 and 3.3 volts. What UEFI does in the seconds before the system starts.
Course contentsLesson 8 of 8
Level 1 · The board and the processor
Level 2 · Graphics cards and AI chips
Level 3 · Drives and how fast they are
Level 4 · Power and start-up
After this lesson you can
- Say what a power supply does
- Size a power supply in watts
- List what UEFI does at start-up
10 mincovers 2 glossary entries
Worth reading first: Motherboard and PCIe Slots
What happens when you press the power button
Two things run before the system you know appears. First, the power supply changes wall power into the steady power the parts need. Then UEFI, a small program on the board, checks the parts and starts the system from a drive. Together they take a few seconds.
A wall socket gives about 230 or 120 volts that flip back and forth. The parts cannot use that. A power supply unit, or PSU, changes it into steady power at 12, 5 and 3.3 volts. The 12 volt line feeds the hungry parts, such as the CPU and the graphics card.
A power supply is rated in watts, which is the most it can give at once. Add up what the parts draw, then leave some room. A strong graphics card can draw over 400 watts alone. A supply that is too small can shut the computer off when it is busy.
Some power is lost as heat on the way. A good supply wastes less. Many carry an efficiency badge, which means at least 80 in every 100 watts reach the parts. Higher badges waste even less, which keeps the fan quiet and the bill lower.
UEFI is the first program to run. It lives on a chip on the board, not on a drive. It checks that the CPU and memory are there and working. Then it looks for a drive to start from, in an order you can set, and hands over to the system on it.
UEFI took over from an older program called BIOS, and many people still say BIOS. It has a setup screen, often opened by pressing a key such as F2 or Delete at start-up. There you can change the boot order, switch on features and set the clock.
One setting there is Secure Boot. It only starts a system that carries a trusted signature, which blocks some kinds of attack. It can also block a home-made or older system from starting. Switching it off fixes that, but drops the protection with it.
Worked example
Emma plans a power supply
Emma's new build has a CPU that draws up to 150 watts and a graphics card that draws up to 320. The board, drives and fans add about 80.
That is 550 watts at full load. She buys a 750 watt supply with a gold efficiency badge, which leaves room for a bigger card later.
The words for this lesson2
Check yourself
What does UEFI do when a computer starts?
Finished this lesson?
Marking it complete also marks its 2 glossary entries learned, which updates your roadmap and your saved page. 0 are already marked.